Field Settings
2. Field Settings
2.1
Outdoor Unit
2.1.1 Setting by Dip Switches
The following field settings are made by dip switches on PCB.
DS1-1
DS1-2
•
1. Connect the cool/heat selector (optional accessory) to the terminals (A, B and C)
2. Set the cool/heat selector switch DS1-1 from "IN (inside) " (which is selected at the
136
Dipswitch
No.
Setting
ON
OFF (Factory setting)
ON
OFF (Factory setting)
Cool/heat selector connection procedure
Set the remote controller only when changing over the operation mode between
cooling and heating using the remote controller installed in the outdoor.
on the outdoor PCB (A4P).
factory before shipment) to "OUT (outside) ".
Setting item
Cool / Heat
Used to set cool / heat change over setting by remote
change over
controller equipped with outdoor unit.
setting
Not used
Do not change the factory settings.
A2P
A4P
DS1-1
A B C
switch knob
DS1 1 2
A B C
Cool/heat
selector
SiBE18-821_C
Description
C/H
SELECTOR
(R9205)
Test Operation and Field Settings