Toshiba e-STUDIO167 Service Manual page 77

• The ADU sensor (on the ADU board) does not detect paper in a fixed period of time when the
paper is transported within the ADU.
È
Paper jam (E51)
• Registration sensor detects jamming of the leading edge of paper:
Registration sensor is not turned ON in a fixed period of time after the feeding starts.
È
Paper jam (E12, E13, E21, E30 and E33)
(The error code differs depending on the paper source. Refer to the error code table in Service
Handbook.)
• The PFU paper feed sensor is not turned ON in a fixed period of time after the pickup solenoid is
turned ON.
È
Paper jam (E14)
• The PFP upper drawer feed sensor is not turned ON in a fixed period of time after the paper feed
clutch is turned ON when paper is fed out of the PFP.
È
Paper jam (E15 and E36)
• The PFP lower drawer feed sensor is not turned ON in a fixed period of time after the paper feed
clutch is turned ON when paper is fed out of the PFP.
È
Paper jam (E16)
• The PFU feed sensor is not turned ON in a fixed period of time after the paper feed clutch is turned
ON when paper is fed out of the PFP.
È
Paper jam (E32 and E35)
(The error code differs depending on its paper source. Refer to the error code list in the Service
Handbook.)
(D) Replace the toner cartridge
• Toner density becomes low
È
Auto-toner sensor detects the absence of the toner
È
Control circuit Æ The toner lamp brinks: the copying operation disabled
Solution: Open the front cover and replace the toner cartridge with a new one.
Toner is supplied Æ copying operation enabled.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
4 - 9
e-STUDIO167/207/237
GENERAL OPERATION
4