Toshiba e-STUDIO167 Service Manual page 43

(4) Disconnect 7 connectors.
(5) Remove 1 screw and 1 ground wire.
Note:
Make sure that the position is correct when
inserting the connector.
(6) Remove 8 screws, release 1 locking support,
and take off the switching regulator board.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
Connector
Fig. 2-33
Green/Yellow
Black
White
White Gray
Black Brown
Fig. 2-34
Locking support
Fig. 2-35
2 - 27
Connector
Switching regulator board
e-STUDIO167/207/237
OUTLINE OF THE MACHINE
2