Toshiba e-STUDIO167 Service Manual page 233

(4) Remove 1 C-ring and 1 bushing on the front
side of the fuser roller.
(5) Remove 1 C-ring, 1 gear and 1 bushing on
the rear side of the fuser roller.
[H] Pressure roller
(1) Take off the pressure roller unit.
P.13-12 "[B] Pressure roller unit / Fuser
roller unit"
(2) Remove 3 screws, and then take off the
fuser unit entrance guide.
(3) Remove 2 springs.
Note:
When installing the spring, be sure to hang
the spring on the upper hook.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
Bushing
C-ring
Fig. 13-26
Fuser unit entrance guide
Fig. 13-27
Spring
Fig. 13-28
13 - 19
C-ring
Gear
Bushing
e-STUDIO167/207/237
FUSER / EXIT UNIT
13