Toshiba e-STUDIO167 Service Manual page 40

[B] SRAM board (SRAM)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Release 1 lock support and take off the
SRAM board.
Notes:
1. Be sure to perform "08-388" after the
SRAM board has been replaced.
2. Perform "05-310" with the platen cover
and the ADF/RADF closed after replacing
the SRAM board.
3. Make sure that the direction of the battery
on the SRAM board is correct when
replacing it.
[C] Fuse PC board (FUS)
Note:
This fuse PC board is copacked with the damp heater unit. (The damp heater unit is optional for
NAD, CND and MJD.)
(1) Take off the rear cover.
P.2-22 "[J] Rear cover"
(2) Remove 2 screws and take off the cover.
e-STUDIO167/207/237
OUTLINE OF THE MACHINE
SRAM board
Battery
Cover
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
2 - 24
SRAM board
Fig. 2-25
Fig. 2-26
Fig. 2-27