Toshiba e-STUDIO167 Service Manual page 207

(4) Remove 2 plate springs fixing the doctor
sleeve on its both ends.
(5) Remove 2 screws on both ends of the doctor
sleeve and remove 2 coil springs.
Note:
When the screws on both ends of the doctor
sleeve are removed, be sure to adjust the
doctor sleeve gap (0.45±0.05 mm) after
assembling.
(Refer to Service Handbook Chap.3.8)
(6) Remove 1 screw and take off the polarity
adjustment lever.
Note:
Make a note of the position where the polar-
ity adjustment lever is pointing. (Mark the
position if needed.) When reassembling,
match the polarity adjustment lever with the
previously marked position on the scale.
© February 2007 TOSHIBA TEC CORPORATION All rights reserved
Plate spring
Fig. 12-16
Coil spring
Screw
Fig. 12-17
Fig. 12-18
12 - 15
Plate spring
Coil spring
Screw
Polarity adjustment lever
e-STUDIO167/207/237
DEVELOPMENT SYSTEM
12