Toshiba RAV-SP560AT-E Service Manual page 81

No. Item
<HEAT>
5 Air speed
selection
(Continued)
Value in the parentheses indicates one when thermo-
stat of the remote controller works.
Value without parentheses indicates one when thermo-
stat of the body works.
• If the air speed has been changed once, it is not
• When heating operation has started, the air speed
• If the temperature is just on the difference boundary,
• Mode in the parentheses indicates one in automatic
• In Tc ≥ 60°C, the air speed increases by 1 step.
3) In heating operation, the mode changes to [UL] if
4) If Ta ≥ 25°C when heating operation has started and
5) In automatic cooling/heating operation, the revolu-
6 Cool air 1) In heating operation, the indoor fan is controlled
discharge
preventive
control
Outline of specifications
Ta (˚C)
L(L)
(-0.5) –1.0
L(H)
(0) Tsh
H(H)
(+0.5) +1.0
H
(HH)
(+1.0)
+2.0
HH
(+1.5) +3.0
(HH)
(+2.0)
+4.0
changed for 1 minute. However when the air speed is
exchanged, the air speed changes.
selects a upward slope, that is, the high position.
the air speed does not change.
heating operation.
thermostat is turned off.
when defrost operation has been cleared, it oper-
ates with HIGH (H) mode or (HH) for 1 minute from
when Tc has entered in E zone of cool air discharge
preventive control (Item 6).
tion frequency of [HH] is set larger than that in the
standard cooling/heating operation. However the
revolution frequency is restricted in the automatic
heating operation as shown in the following figure.
based on the detected temperature of Tc sensor or
Tcj sensor. As shown below, the upper limit of the
revolution frequency is determined.
Tc
(˚C)
Tcj
HH
32
H
30
L
28
UL
26
OFF
20
16
E
D
C
B
A
E zone
D zone
C zone
B zone
A zone
– 81 –
RAV-SM561/801/1101/1401CT-E
Remarks
[PRE-HEAT] display
F5 F4
Tc
(˚C)
47
42
F5
In D or E zone, the priority is
given to setup of air volume
exchange.
In A and B zones,
[PRE-HEAT] is displayed.