Toshiba RAV-SP560AT-E Service Manual page 78

No. Item
13 Energy-save 1) Selecting [AUTO] mode enables an energy-saving to
control
(By connected
2) The setup temperature is shifted (corrected) in the
outdoor unit)
3) Data (Input value room temp. Ta, Outside temp. To,
4) The setup temperature is shifted every 20 minutes,
14 Max. frequency 1) This control is operated by selecting [AUTO] operation
cut control
2) COOL operation mode: the frequency is controlled
3) HEAT operation mode: the frequency is controlled
15 DC motor 1) When the fan operation has started, positioning of the
2) The motor operates according to the command from
NOTES :
• When the fan rotates while the air conditioner stops
• When a fan locking is found, the air conditioner stops,
Outline of specifications
be operated.
range not to lose the comfort ability according to input
values of various sensors.
Air volume, Indoor heat exchanger sensor temp. Tc)
for 20 minutes are taken the average to calculate
correction value of the setup temperature.
and the shifted range is as follows.
In cooling time : +1.5 to –1.0k
In heating time : –1.5 to +1.0k
mode.
according to the following figure if To < 28°C.
Ta(˚C) Normal control
+4
+3
Tsc
according to the right figure if To > 15°C.
Ta(˚C)
Tsh
–3
–4
Normal control
stator and the rotor are performed.
(Moves slightly with tap sound)
the indoor controller.
due to entering of outside air, etc, the air conditioner
may operated while the fan motor stops.
and an error is displayed.
Max. frequency is restricted
to approximately the rated
cooling frequency
Max. frequency is restricted
to approximately the rated
heating frequency
– 78 –
RAV-SM561/801/1101/1401BT-E
Remarks
Check code [P12]