Toshiba RAV-SP560AT-E Service Manual page 192

No. Part name
‡
Compressor 1) Perform works of items 1 of
2) Discharge refrigerant gas.
3) Remove the partition plate.
4) Remove the noise-insulator.
5) Remove the terminal covers of the
6) Remove pipes connected to the
7) Take off the fixing screws of the
8) Take off the fixing screws of the valve
9) Pull upward he refrigerating cycle.
10) Take off nut fixing the compressor
ˆ
Reactor 1) Perform works of item 1 of
2) First take off two screws (ST1T Ø4 x
3) Remove the reactor support from the
4) Take off two screws (ST1T Ø4 x 10L)
Procedure
‚ ƒ „ …
, , , .
(ST1T Ø4 x 10L, 2 pcs.)
compressor, and disconnect lead
wires of the compressor and the
compressor thermo assembly from
the terminal.
compressor with a burner.
CAUTION
Pay attention to that flame does not
involve 4-way valve or PMV. (If doing
so, a malfunction may be caused.)
bottom plate and heat exchanger.
(ST1T Ø4 x 10L, 2 pcs.)
clamping plate to the bottom plate.
to the bottom place.
CAUTION
When reconnecting the lead wires to
the compressor terminals after
replacement of the compressor, be
sure to caulk the Faston terminal
without loosening.
10L) of the reactor fixed to the reactor
support.
partition plate.
(ST1T Ø4 x 10L, 4 pcs.)
directly attached to the partition plate.

and
Remove
(Discharge pipe)
Remove
(Suction pipe)
 ƒ
and .
– 192 –
RAV-SM560AT-E
Remarks
Partition plate
Compressor
lead
Case thermo
Heat exchanger
Screw
Valve
support board
Screws (2 pcs.)
Compressor bolt (3 pcs.)
Partition
Reactor
plate
Reactor
support board