Toshiba RAV-SP560AT-E Service Manual page 75

No. Item
<HEAT>
5 Air speed
selection
(Continued)
Value in the parentheses indicates one when thermostat of
the remote controller works.
Value without parentheses indicates one when thermostat
of the body works.
• If the air speed has been changed once, it is not
• When heating operation has started, the air speed
• If the temperature is just on the difference boundary, the
• Mode in the parentheses indicates one in automatic
• In Tc ≥ 60°C, the air speed increases by 1 step.
3) In heating operation, the mode changes to [UL] if
4) If Ta ≥ 25°C when heating operation has started and
5) In automatic cooling/heating operation, the revolution
6 Cool air 1) In heating operation, the indoor fan is controlled based
discharge
preventive
control
Outline of specifications
Ta (˚C)
L(L)
(-0.5) –1.0
L(H)
(0)
Tsh
H(H)
(+0.5) +1.0
H
(HH)
(+1.0) +2.0
HH
(+1.5) +3.0
(HH)
(+2.0) +4.0
changed for 1 minute. However when the air speed is
exchanged, the air speed changes.
selects a upward slope, that is, the high position.
air speed does not change.
heating operation.
thermostat is turned off.
when defrost operation has been cleared, it operates
with HIGH (H) mode or (HH) for 1 minute from when Tc
has entered in E zone of cool air discharge preventive
control (Item 6).
frequency of [HH] is set larger than that in the standard
cooling/heating operation. However the revolution
frequency is restricted in the automatic heating opera-
tion as shown in the following figure.
on the detected temperature of Tc sensor or Tcj sensor.
As shown below, the upper limit of the revolution
frequency is determined.
Tc
(˚C)
Tcj
HH
32
H
30
L
28
UL
26
OFF
20
16
E
D
C
B
A
E zone
D zone
C zone
B zone
A zone
– 75 –
RAV-SM561/801/1101/1401BT-E
Remarks
[PRE-HEAT] display
F5 F4
Tc
(˚C)
47
42
F5
In D or E zone, the priority
is given to setup of air
volume exchange.
In A and B zones,
[PRE-HEAT] is displayed.