Toshiba RAV-SP560AT-E Service Manual page 151

<Wired remote controller>
1. When pushing button on the remote controller for 4 seconds or more, "TEST" is displayed on LC display.
Then push button.
• "TEST" is displayed on LC display during operation of Test Run.
• During Test Run, temperature cannot be adjusted but air volume can be selected.
• In heating and cooling operation, a command to fix the Test Run frequency is output.
• Detection of error is performed as usual. However, do not use this function except case of Test Run be-
cause it applies load on the unit.
2. Use either heating or cooling operation mode for [TEST].
NOTE : The outdoor unit does not operate after power has been turned on or for approx. 3 minutes after
operation has stopped.
3. After a Test Run has finished, push
(To prevent a continuous test run operation, 60-minutes timer release function is provided to this remote
controller.)
12-1-2. Setup to Select Function
<Procedure> Use this function while the indoor unit stops.
1
Push , , and
SET
The unit No. displayed at the first time indicates the indoor unit address of the master unit in the group control.
In this time, fan and flap of the selected indoor unit operate.
2
Every pushing
In this time, fan and flap of the selected indoor unit only operate.
3
Using the set temperature
4
Using the timer time
5
Push button. (OK if display goes on.)
SET
• To change the selected indoor unit, proceed to
• To change the item to be set, proceed to
6
Pushing button returns the status to usual stop status.
button again and check that [TEST] on LC display has gone off.
buttons concurrently for 4 seconds or more.
button, the indoor unit numbers in the group control are displayed successively.
/ buttons, set the item code (DN).
/ buttons, select the setup data.
3
4
6
1
<Operation procedure>
1 2 3
RAV-SM561/801/1101/1401BT-E
RAV-SM560/800UT-E, RAV-SM560/800BT-E
RAV-SP1100UT-E
2
.
.
SET DATA
UNIT No.
R.C. No.
UNIT
SET CL
5 2
4 5 6
END
– 151 –
3