DataCard ImageCard series Manual page 78

5-4
Advanced information
Verify the ECP parallel port configuration — system
query
1.
Close all open applications.
2.
Reboot the PC.
3.
Enter the PC BIOS setup program following the instructions that
display early in the reboot sequence (or see the documentation that
came with your PC for information on entering this program).
4.
In the PC BIOS setup program, check to see that the parallel port
mode is set to ECP. If it is not, set it to ECP.
5.
Exit the PC BIOS setup program, following the instructions on the
screen.
If you cannot change the parallel port mode to ECP in the PC
BIOS setup program, call your DataCard-authorized service
provider for assistance.
!