DataCard ImageCard series Manual page 54

ImageCard/UltraGrafix (Express and Select Classes) User's Guide
5.
Insert the cleaning card near the bottom of the card cartridge cavity
(see Figure
3:-13
6.
Start a cleaning cycle by doing one of the following:
Click the OK button when the printer driver displays a message
•
requesting that you clean the printer. (If you do not click OK at
this point, the message will redisplay before printing each card
until you run a cleaning cycle.)
Click the Clean printer now button in the printer driver status
•
monitor window. (Right-click on the printer icon in the lower
right corner of the screen and select Display status to see the
status monitor window.)
7.
Remove the cleaning card from the card output stacker after the
printer has completed the cleaning cycle.
8.
Replace the card cartridge.
9.
Replace the ribbon cartridge.
a)
Lift open the top cover.
b)
Press down on the swing arm. The push latch will release the
swing arm. Lift the swing arm until it is fully open.
c)
Place the ribbon cartridge onto the ribbon cartridge supports and
press down until it clicks into place (see Figure
d)
Close the swing arm, pressing it down until the push latch clicks
into place.
e)
Close the top cover.
10.
Discard the used cleaning card. The rollers are clean, and the printer
is ready to resume normal operation.
).
!
3-13
).
3:-12