Footprint Iii Filtration System Preventive Maintenance Checks And Services - Frymaster 47 SERIES Installation, Operation, Service, And Parts Manual

3. Insert the fitting for a gas pressure-
measuring device into the pressure tap
hole.
4. Place the gas valve in the ON position then
place the fryer power switch in the ON
position. When the burner lights and
continues to burn, note gas pressure
reading for correct pressure in accordance
with the accompanying tables.
Non-CE Standard
Burner Manifold Gas
Pressures
Gas
Natural
LP
CE Standard
Burner Manifold Gas Pressures
Gas
Natural Gas Lacq
(G20) under 20 mbar
Natural Gas Gronique *
(G25) under 25 mbar
Propane
(G31) under 37 or 50 mbar
* Belgian G25 = 7,0 mbar
5. To adjust burner gas pressure, remove the
cap from the gas valve regulator and adjust
to correct pressure.
6. Place the fryer power switch and the gas
valve in the OFF position. Remove the
fitting from the pressure tap hole and
reinstall the pressure tap plug.
47 SERIES GAS FRYERS
CHAPTER 5: PREVENTIVE MAINTENANCE
Pressure
3.5" W.C.
0.8 kPa
8.25" W.C.
2.5 kPa
Pressure
(mbar)
8
10
21
5.2 FootPrint III Filtration System
Preventive Maintenance Checks
and Services
Always allow cooking oil/shortening to
cool below 100ºF (38ºC) before trans-
porting to the disposal area.
Frymaster recommends the use of a
Shortening Disposal Unit, available
from your local distributor, for your
Never operate the filter system without
cooking oil/shortening in the system.
Never use the filter pan to transport old
cooking oil/shortening to the disposal
Never drain water into the filter pan.
Water will damage the filter pump.
There are no periodic preventive maintenance
checks and services required for your
FootPrint III Filtration System other than daily
cleaning of the filter pan with a solution of hot
water and detergent.
If you notice that the system is pumping
slowly or not at all, verify that the filter pan
screen is on the bottom of the filter pan, with
the paper on top of the screen. If the filter
screen and paper are correctly installed,
change the filter paper and verify that the
o-ring on the bottom of the filter pan is present
and in good condition.
5-5
DANGER
safety.
WARNING
WARNING
area.
WARNING