Replacing Control Panel Power Indicator Light In Fryers With Thermostat Controls; Replacing Power Or Melt Cycle Switch In Fryers With Thermostat Controls; Replacing Melt Cycle Timer Motor In Fryers With Thermostat Controls - Frymaster 47 SERIES Installation, Operation, Service, And Parts Manual

7. Disconnect the 12-pin plug from the back
of the interface board and lay board in the
left end of compartment with all other
wires still connected.
8. Remove the high-limit thermostat wires
from the gas valve pilot coil and pull them
up through the control shield.
9. Unscrew the high-limit thermostat from
the frypot and remove.
10. Apply Loctite™ PST56765 thread sealant
or equivalent to new thermostat threads.
11. Reverse steps 1 through 9 to install the
replacement thermostat.
7.8.6 Replacing Control Panel Power
Indicator Light in Fryers with
Thermostat Control
1. Disconnect the fryer from the electrical
supply.
2. Remove the thermostat knob.
3. Remove the screws from the upper left and
right corners of the control panel. The
control panel is hinged at the bottom and
will swing open from the top.
4. Unplug the control panel wiring harness
from the component shield/control box.
5. Carefully press the light out of the back
side of the control panel. Remove one
wire terminal at a time and connect to the
replacement light until all wires are trans-
ferred.
6. Carefully press the light back into the
control panel.
47 SERIES GAS FRYERS
CHAPTER 7: SERVICE PROCEDURES
7-12
7. Reverse steps 1-4 to reassemble fryer.
7.8.7 Replacing Power or Melt Cycle
Switch in Fryers with
Thermostat Controls
1. Disconnect the fryer from the electrical
supply.
2. Remove the thermostat knob.
3. Remove the screws from the upper left and
right corners of the control panel. The
control panel is hinged at the bottom and
will swing open from the top.
4. Unplug the control panel wiring harness
from the component shield/control box.
5. Unsnap the chrome bezel from the rear of
the switch and push the switch out through
the rear of the control panel.
6. Remove wires one at a time from the
switch and connect to the replacement
switch until all wires are transferred.
7. Reverse steps 1-5 to reassemble fryer.
7.8.8 Replacing Melt Cycle Timer
Motor in Fryers with Thermostat
Controls
1. Disconnect the fryer from the electrical
supply.
2. Remove the thermostat knob.
3. Remove the screws from the upper left and
right corners of the control panel. The
control panel is hinged at the bottom and
will swing open from the top.