Frymaster 47 SERIES Installation, Operation, Service, And Parts Manual page 102

Fryer Heat Shield
The heat shield has been modified by cutting a
notch in the back edge to allow mounting of
the pump discharge hose support bracket to
the heat shield above the filter base assembly.
It includes a new hose support (essentially a
tray) attached to the inside right rear corner to
keep the hose clear of other filter components.
Important: The pump discharge hose must
stay above the hose support when the filter
tray is pushed in under the fryer.
Abbreviated Parts List (See illustrations on Pages 7-40 through 7-42)
ITEM PART #
1 810-1421
2 810-1372
3 810-1370
4 810-1369
5 810-1373
6 810-1423
* 900-5673
7 823-2585
8 823-2584
9 823-2583
10 810-1003
* 813-0156
11 807-2484
* 811-0932
* 810-1362
12 810-1394
* 810-1395
* Not illustrated.
47 SERIES GAS FRYERS
CHAPTER 7: SERVICE PROCEDURES
Cable, Filter, FP47
Fitting, 90º (for use with Teflon vent tube P/N 812-1322)
Flexline, Dormont, ½-inch X 9-inch (to Power Shower)
Flexline, Dormont, ½-inch X 18.5-inch (filter to manifold)
Flexline, Dormont, ¼-inch X 6-inch (pump bypass)
Hose, Teflon w/Stainless Braiding, ½-inch X 30-inch (from pump)
Shield, Heat, FP47
Square Drain Section, End, Left, Long (for full vat)
Square Drain Section, End, Left, Short (for dual vat left)
Support, Oil Return, FP47
Valve, Ball, 3-Way, 180º
Plug, ½-inch BM Pipe (used to close left valve port on full vat units)
Valve, Vent, Solenoid, ¼" NPT (for use on manifold and pump)
Vent Tube, ⅜-inch O.D., Teflon
Manifold, FP47 Power Shower Oil Return
FP247
FP347
FP447
Verifying Solenoid Operation
Proper operation of the 24 VAC manifold and
pump solenoids can be verified by removing
the pump motor lead from terminal 4 of the
pump motor relay in the filter wiring box and
then activating the oil return lever. Proper
solenoid operation will be evidenced by an
audible "click" or vibration of the solenoids.
COMPONENT
7-43