Frymaster 47 SERIES Installation, Operation, Service, And Parts Manual page 74

7. Remove the thermostat flexible shaft from
the thermostat shaft adjusting screw.
8. Remove the two screws and nuts from the
thermostat shaft bracket and lift the ther-
mostat flexible shaft and bracket out of the
component box.
9. Disconnect both wires from the gas valve
and the 20-hole terminal block. Skip to
Step 14.
10. For fryers equipped with other than Ther-
mostat Controls, remove the screws from
the upper left and right corners of the con-
trol panel. Disconnect the controller from
the fryer wiring harness and remove it
from the fryer.
11. Remove the two screws and nuts from the
base of the interface board bracket.
12. Disconnect the 12-pin plug from the back
of the interface board and remove the tem-
perature probe and high-limit thermostat
wires from the plug using a pin pusher.
13. Lay the interface board and bracket on top
of the control shield with wires still con-
nected.
14. Remove the louvered frame above the
control panel opening.
15. Remove screws and nuts securing the
component box to the fryer.
16. Disconnect wires from components in
component box and mark to facilitate re-
connection.
17. Remove pilot generator fitting from gas
valve pilot coil and lift the high-limit
47 SERIES GAS FRYERS
CHAPTER 7: SERVICE PROCEDURES
7-15
thermostat wire adapter from the slot. Pull
the high-limit thermostat wires and adapter
up through the grommet at the rear of the
box.
18. Remove the wires from the gas valve ter-
minal block. Mark each wire to facilitate
reconnection.
19. For fryers equipped with Thermostat Con-
trols, remove the thermostat wire from the
gas valve and pull it up through the grom-
met at the rear of the box. Disconnect the
other thermostat wire from the 20-hole
terminal block. Mark each wire to facili-
tate reconnection.
20. Remove the cover from the safety drain
switch, disconnect the wires from the
switch, and pull them out of the switch
box.
21. Pull up and forward on the component box
to clear the rear mounting stud on the front
of the frypot.
22. Remove the component box from the fryer
by rotating its right side up and to the left.
23. Remove the pipe union from the right side
of the gas valve.
24. Remove the section of square drain from
the drain valve of the frypot to be re-
moved.
25. Remove the frypot hold down bracket.
26. Remove the screws from the flue cap sides
and back and lift it clear of the fryer(s).
27. Remove the oil return hose or line from
the front of the frypot to be removed.