Brush Installation; Changing The Water Bottle - Windsor 1.005.293.0 Operating Instructions Manual

Operation

Brush Installation

Put the machine base in an upright position, sitting on the foot of the bumper.
Remove the driver plate by removing the four countersink screws in the center of the plate using an electric screw-
driver.
It is important to only use a Number 3 Phillips head screwdriver bit. Smaller bit sizes can damage the screw heads
and leave sharp edges, which can tear or snag the pads.
Il est important de n'utiliser qu'un embout de tournevis Phillips numéro 3. Des embouts de tailles inférieures
peuvent endommager les têtes de vis et laisser des arêtes vives, qui peuvent se déchirer ou accrocher les
tampons.
Mount the brush with the same countersink screws used for mounting the driver plates.
NOTE: Tighten the screws sufficiently to avoid disengagement of the brush from the machine during operation
NOTE: Serrez les vis suffisamment pour éviter le désengagement de la brosse pendant le fonctionnement
l'appareil..
To avoid stripping the screws do not over tighten. An electric screwdriver with a clutch will ensure that stripping will
not occur.

Changing the Water Bottle

To put the water bottle in the cage holder, place the bottle at an angle over the cage hoop. Push the bottle into the
cage hoop so that you can push it without much effort into the cage hoop holder.
Push the bottle down until it rests firmly
To remove the water bottle from the cage holder, proceed in reverse order:
Pull the water bottle out of the holder, as soon as the bottom of the bottle hits the cage hoop, tilt the bottle and pull
it up and out at an angle. Remove the bottle from the cage holder and place it next to the machine on the floor
To remove the cap and spray hose from the water bottle, unscrew the bottle cap counter clockwise. Remove the
hose and the filter from the water bottle. Seal the water bottle with a separate cap provided if needed for storage.
To connect the cap and spray hose to the water bottle, proceed in reverse order.
Secure cap to bottle until firmly sealed.
22 86375030 Manual