Attaching And Removing The Driver Plates - Windsor 1.005.293.0 Operating Instructions Manual

Attaching and Removing the Driver Plates

Put the machine base in an upright position, sitting on
the foot of the bumper. Remove the driver plate by
removing the four countersink screws in the center of
the plate using an electric screwdriver.
It is important to only use a Number 3 Phillips head
screwdriver bit as smaller bit sizes can damage the
screw heads. Damaged screws can cause further
damage.
Il est important de n'utiliser qu'un embout de tournevis
Phillips numéro 3, car des tailles d'embouts inférieurs
peuvent endommager les têtes de vis. Les vis endom-
magées peuvent causer d'autres dommages.
Attach a driver plate to the machine base by lining up
the holes of the driver plate with the appropriate
threads of the bearing retainer ring. It is recommended
to align the threads of the bearing horizontally to the
ground.
Put the four countersink screws through the holes of
the driver plate and first screw them into the bearing
retainer ring threads manually.
Then, tighten the screws with an electric screwdriver
NOTE: Tighten the screws sufficiently to avoid
disengagement of the driver plate from the machine
base during operation.To avoid stripping the screws
do not over tighten. An electric screwdriver with a
clutch will ensure that stripping will not occur.
NOTE: Serrez les vis suffisamment pour éviter le
désengagement de la plaque d'entraînement pendant
le fonctionnement l'appareil. Pour éviter
d'endommager les vis, ne les serrez pas trop. Un
tournevis électrique avec embrayage veillera à ce
qu'il y ait aucun endommagement.
86375030 Manual
Operation
23