Table of Contents
Advertisement
Operating The Machine
Expected Run Time
The expected run time for this machine depends upon
which mode the machine is in. This duty cycle includes
an amount of time that the machine will be running
along with a period of time that the machine should be
off to empty the Recovery Tank, fill the Solution Tank,
check the Brush, and remove debris from the Debris
Tray.
Typical Run Time for each Mode:
Deep Extract 10 minutes ON
10 minutes OFF
Eco Mode
30 minutes ON
10 minutes OFF
Interim Mode 60 minutes ON
10 minutes OFF
Brush Height Adjustment
Brush Height Adjustment Knob
Before adjusting brush height, transport the machine to
the work area by lifting the scrubbing head off of the
ground and rolling the machine on the rear wheels.
1. To set brush height for cleaning mode and carpet
type:
•
Place the machine on the deck kick stand by
tipping the machine back about 30 degrees and
then setting the machine deck back to the
ground.
86409500 Operator's Manual - Armada BRC 40/22
•
Rotate the brush height adjustment knob to
position "1" which is the highest brush position.
Roll the machine forward to lower the machine
off the kickstand.
•
Run the machine on the carpet to be cleaned.
The machine should now assist in the forward
direction due to the brush running on the carpet.
If not, raise the deck back onto the kickstand
and rotate the brush height adjustment knob to
the next lower brush position.
•
Re-run the machine on the carpet and test for
forward assist; repeat previous step if neces-
sary.
•
If after a few seconds of running the brush light
flashes red, rotate the brush height adjustment
knob to the next lower number position which
raises the brush and retest. If the brush light
continues to flash red, consult the Trouble-
shooting section.
2. Select a mode from the Main Rotary Control Switch
for the desired results.
See Controls section for detailed description of
each function.
Operations
STEP 2
19
Hide quick links:
Advertisement
Table of Contents
