Changing The Filters - Windsor 1.005.293.0 Operating Instructions Manual

Maintenance

Changing the filters

If the spray jets become clogged or should leak, this is a sign that the filters must be changed.
To change the filters, open the spray jet caps by turning the caps with a suitable wrench counterclockwise. Fix the
spray jet body with a wrench using the other hand for stabilization.
Remove the spray jet caps. The spray tip and the check ball valve filter can now be removed easily from the spray
jet body.
Insert the new filter in the spray jet body housing, place the spray tip inside the cap, put the cap on the thread and
turn clockwise to seal.
Seal the cap firmly by using the appropriate wrenches. The spray jets can now be operated as usual.
Make sure to align the slits of the spray jet tips in a horizontal plane to the floor to allow for an even spray pattern.
A: Cap
B: Spray Tip
C: Check Ball Valve Filter
NOTE: Use all manufacturer accessories and recommended parts only for operating.
The use of inappropriate driver plates, pads, brushes or weights can damage the machine and the floor.
Use only manufacturer recommended parts and pads or the warranty will be voided.
30 86375030 Manual