Operation Panel Unit; Removing The Scanner Unit; Removing The Board Unit; Removing The Operation Panel Unit - Canon LaserBase MF3220 Series Service Manual

[4]
[1]

3.1.6.6 Removing the Scanner Unit

1) Remove the connector [1] and the flat cable [2] on the ECNT board, and
remove the screw [3]. (Remove the flat cable from the core.)
2) Remove the 2 screws [4] and the 2 pins [5] on the right and left sides.
[1]
3) Remove the scanner unit [1] by sliding it to the rear and lifting it up.
- 2 screws [2]
[1]

3.1.6.7 Removing the Board Unit

1) Remove the four screw[1]onthe back of scanner unit.
[2]
[4]
[3]
F-3-27
[3]
[4]
[5]
[2]
F-3-28
[2]
F-3-29
2) Open the board unit [1] and disconnect the connector [2] and two flat
cables [3].
0012-1492
[3]

3.1.6.8 Removing the Operation Panel Unit

1) Detach the flat cable cover, and remove the flat cable [1] from the core [2].
- 2 screws [3]
2) Remove the 2 claws [2] on the operation panel unit [1], and remove the

operation panel unit.

0012-1494
[1]
F-3-30
[1] [2]
F-3-31
[3]
[2] [1]
F-3-32
Chapter 3
0012-1496
3-5