Strobe Adjustment - Sony DSC-F828 Adjustment

DSC-F828

17. Strobe Adjustment

Adjust the light level and white balance when the strobe light flashes.
Mode
Subject
Measurement Point
Measuring Instrument
Adjustment Page
Adjustment Address
Specified Value1
Specified Value2
Note1: Perform this adjustment in the dark room or use the flash
adjustment box.
Note2: Any light other than the strobe light should not light up the plate.
Note3: After the power is turned on, this adjustment can be done only
once.
Note4: If the data of page: 60, address: 02 is "01", select page: 60, address:
01, and set data: 00.
Switch setting:
ZOOM .................................................................... WIDE end
FLASH ......................................................................... OPEN
Adjusting method:
Order Page Address Data
1
2 60 2C
3 60 92
4 60 93
5 60 6C
6 60 01
7
8 60 07
9 6E 4F
10 60 01
11
12 60 02
13 6F D8
14 60 01
15
16 60 ED
17
18 60 01
19
20 60 02
21 6F D8
22 6F DC
23 6E 4F
Note5: The adjustment data will be automatically input to page: 6F,
address: D8 to EF, and to page: 6E, address: 72 to 75.
STILL (P AUTO) (P)
Background paper (J-2501-130-A)
(50cm from the front of the lens)
Data of page 6F, address: DC
Data of page 6E, address: 4F
6F 6E
D8 to EF 72 to 75
03 to 09
00
Procedure
Check that "1. Data Setting
during Camera System
Adjustments" is performed.
01 Set the data.
FF Set the data.
FF Set the data.
01 Set the data.
79 Set the data.
Wait for 5 sec.
Read the data, and check it is "01".
FF Set the data.
B9 Set the data.
Check the flashing.
Read the data, and check it is
"01". (Note5)
Read the data, and check it is "00".
00 Set the data.
Wait for 5 sec.
Read the data, and check it is "02".
Wait for 1 sec.
E7 Set the data.
Check the flashing.
Read the data, and check it is "01".
Read the data, and check it is "00".
Read the data, and check it
satisfies the specified value 1.
Read the data, and check it
satisfies the specified value 2.
Processing after Completing Adjustments:
Order Page Address Data
1 60 01
2 60 2C
3 60 6C
4 60 92
5 60 93
6
6-28
Procedure
00 Set the data.
00 Set the data.
00 Set the data.
00 Set the data.
00 Set the data.
If finish the camera system
adjustments, release the data
setting.
(See "1. Data Setting during
Camera System Adjustments".)