Adjustments; Before Starting Adjustment - Sony DSC-F828 Adjustment

1.

Before starting adjustment

Procedure 1
Save the EVR data of the machine in which a board is going to be replaced. Download the saved data after a
board is replaced.
(Machine before starting repair)
Procedure 2
Remove the flash memory from the board of the machine that is going to be repaired. Install the removed
flash memory to the replaced board.
Procedure 3
When the data cannot be saved due to defective flash memory, or when the flash memory cannot be removed
or installed, save the data from the same model of the same destination, and download it.
(The same model of the same destination)
After the EVR data is saved and downloaded, check the
respective items of the EVR data.
(Refer to page 6-3 for the items to be checked.)
DSC-F828
EVR Data Re-writing Procedure When Replacing Board
The data that is stored in the repair board, is not necessarily correct.
Perform either procedure 1 or procedure 2 or procedure 3 when replacing board.
Save the EVR data
to a personal computer.
Remove the flash memory and install it.
(Former board)
(Machine to be repaired)
Save the data.
SECTION 6

ADJUSTMENTS

PC PC
(New board)
PC
6-1
(Machine after a board is replaced)
Download the saved
data to a machine.
(Machine to be repaired)
Download the data.