Lcd System Adjustment; Data Setting During Lcd System Adjustments; Lcd Initial Data Input - Sony DSC-F828 Adjustment

1-6.

LCD SYSTEM ADJUSTMENT

Note1: When replacing the LCD unit, be careful to prevent damages
caused by static electricity.
Note2: If you perform the adjustments with FINDER/LCD switch (Control
switch block (UNDER)) removed, set the following data.
1) Select page: 80, address: 10, and set data: 1A.
2) Select page: 80, address: 11, and set data: 00.
Reset the data after completing adjustment.
1) Select page: 80, address: 10, and set data: FF.
2) Select page: 80, address: 11, and set data: 00.
Switch setting:
FINDER/LCD ................................................................. LCD

1. Data Setting during LCD System Adjustments

Perform the following data setting before the LCD system
adjustments.
Note1: When the power is turned off, some data settings will be released.
So perform this data setting again when the power is turned off.
Order Page Address Data
1 00 01 01
2 80 70 01
After completing the LCD system adjustments, release the data
setting.
Order Page Address Data
1 80 70 00
2
3
4 00 01 00
Procedure
Set the data.
Set the data.
Procedure
Set the data.
Save the data.
Wait for 2 sec.
Set the data.

2. LCD Initial Data Input

Mode
Signal
Adjustment Page
Adjustment Address
Adjusting method:
1) Select page: 00, address: 01, and set data: 01.
2) Select page: 8F, and write the data in the following table.
3) Save the data.
4) Wait for 2sec.
5) Select page: 00, address: 01, and set data: 00.
Address Data
20 A5
21 19
23 80
24 76
25 84
26 00
27 63
28 90
2A 80
2C 72
6-35
DSC-F828
PLAY ( )
Arbitrary
8F
20, 21, 23 to 28, 2A, 2C
Remark
Fixed data
Fixed data
VCO adj.
VCOM adj.
Fixed data
Fixed data
Fixed data
White balance adj.
White balance adj.
Contrast adj.