4 POWER switch
Powers the unit on and off.
5 Audio level meter
Displays the recording and playback audio levels of
two (CH-1/2 or CH-3/4) of the four audio channels
(CH-1 to CH-4), as selected with the METER switch
7.
6 WARNING indicator
Lights when the battery is exhausted or an error
occurs.
It flashes in the following cases.
• When the end of battery power is near
• When the number of memorized shot marks reaches
to 200 during shot mark reading or when you start
reading shot marks after 200 marks have been read.
7 METER switch
Selects the audio channel whose level is displayed by
the audio level meter.
CH-1/2: Display the recording, playback, and E-E
levels of audio channels 1 and 2.
CH-3/4: Display the recording, playback, and E-E
levels of audio channels 3 and 4.
1 Submenu Operation Section
Settings made by submenu include video and audio input
and output settings, and reference video signal settings. For
details, see section 2-7-1 "Displays on the Home Page of
the Submenu".
8REC INHI switch
When ON, recording to the tape is inhibited, regardless
of the state of the cassette's erasure prevention plug.
(The REC INHI indicator lights.)
9MONITOR switch
Selects the output from the MONITOR OUTPUT L/R
connectors. Settings made with this switch are enabled
only when audio settings page 1-3 is selected.
1/2: Output the audio signals of channel 1 from the L
MIX: Output the mixed signals of channels 1 and 2
2/1: Output the audio signals of channel 2 from the L
0 Monitor audio level knob
Adjusts the volume of the headphones connected to the
PHONES jack !¡.
This knob can also adjust the level of the audio signal output
from the MONITOR OUT connectors when MONITOR in
the submenu is set to VAR. For details, see page 2-21.
!¡ PHONES (headphones) jack
Connect headphones.
1 FL display panel
TC
525 SX-- BATT
00 : 00 : 00 : 00
AU-1
AUTO
VITCON
SDI
F1
F2
F3
PAGE
3 Operation buttons F1 to
F4
2 PAGE button
connector and the audio signals of channel 2 from
the R connector.
from both the L and R connectors.
connector and the audio signals of channel 1 from
the R connector.
LIST
MARK
F4
DOWN
UP
5 MARK/UP button
4 LIST/DOWN button
1-5
Chapter 1 Overview