Sony Betacam SX DNW-A28 Operation Manual page 82

Extended Menu
Item number Item name
726 H BLANKING
WIDTH
727 VIDEO EDIT
PREVIEW
SWITCHER
728 OUTPUT SCH
PHASE SETTING
730 PICTURE SHIFT
6-20
Chapter 6 Setup Menu
Menu items in the 700s, relating to video control (continued)
Settings
Select the horizontal blanking width of a video output signal.
NARROW: Digital blanking (narrow)
Selecting NARROW is recommended for longer H-period of video when editing is
performed between digital devices.
WIDE : Analog blanking (wide, complied with SMPTE 170A)
Selecting WIDE is recommended for broadcast transmission or editing in which an
analog device (i.e. BVW-series VTR) is used as recorder.
Set the output phase for the video playback signal when any of the ASSEMBLE,
VIDEO, A-CH-1 to A-CH-4, and TC is set to ON in the Edit Preset menu.
INT : The video playback signal output phase is the same as the output phase in the E-
E mode. Use this setting when editing with a single VTR, or when previewing while
watching the VTR output signal.
EXT: The video playback signal output phase is the same as the phase of an input
video signal or external reference signal.
Note
Whichever setting is used, the correct editing results will be obtained. When, however,
you are using an external switcher to switch the video output signal from this unit for the
purposes of preview, select EXT. This will prevent any image shifts at editing IN and
OUT points.
Adjusts the SCH phase.
Default value: 800H
Shifts the picture played back in Betacam SX mode.
OFF : Do not shift.
1/4H: By 1/4 of the display area in the horizontal direction
3/4H: By 3/4 of the display area in the horizontal direction
1/4V: By 1/4 of the display area in the vertical direction
3/4V: By 3/4 of the display area in the vertical direction