Power Preparations; Usable Batteries; Using The Bp-L60(A)/L90(A) Battery Pack - Sony Betacam SX DNW-A28 Operation Manual

2-1 Power Preparations

This unit can be powered by batteries or AC power.
Note
If you attach or remove batteries or AC adaptors
incorrectly, they may fall down and cause body injury.
Follow the procedures described below to attach or
remove them.

2-1-1 Usable Batteries

Batteries that can be used with this unit are as follows.
For each type of battery, a special battery adaptor and
battery charger is required.
Battery
Battery Adaptor Battery Charger
BP-90(A)
DC-L90
(mounted on this
unit)
BP-90(A)
DC-210
(connected to DC
IN connector)
BP-L60(A)/L90(A) BKP-L551
Notes about battery usage
• Before using the batteries, be sure to charge them
fully with the special battery charger. Refer to the
operating instructions of your battery charger for
more information about how to charge the batteries.
• Batteries may not be completely charged if you
charge them immediately after use when they are still
warm. You should wait until the batteries cool before
charging them.
2-1-2 Using the BP-L60(A)/L90(A)
Battery Pack
This unit can be operated for about 80 minutes at
normal temperature on fully charged BP-L90 Battery
Pack.
To charge the battery pack
Before use, charge the battery pack with the BC-L100/
L100CE Battery Charger. It takes about 2.5 hours to
charge the BP-L60(A) and about 3.5 hours to charge
the BP-L90(A).
For more information about how to charge the battery pack,
refer to the manual for the BC-L100/L100CE.
To attach the battery pack
Attach the BP-L60(A)/L90(A) as shown in the figure
below. Before attaching, remove the two screws on the
side panel of this unit.
For details on attaching the BKP-L551, refer to the BKP-
L551 installation manual.
BC-210/210CE/410/
410CE
BC-210/210CE/410/
410CE
BC-L100/
L100CE/L50
1 Screw the BKP-L551 on the side panel.
2 Align the groove on the top panel of the BP-L60(A)/
L90(A) with the guides.
3 Slide the BP-L60(A)/L90(A) in so that its connector is
firmly connected to the battery connector. Use the
optional extension cable (part No. 1-790-446-11) to
connect the DC cable of the BKP-L551 to the DC IN
connecteor on this unit.
Chapter 2 Preparations
2-1