Sony Betacam SX DNW-A28 Operation Manual page 17

3 AUDIO INPUT CH-1/CH-2 connectors (XLR 3-
pin, female)
Input the analog audio signals of input channels 1 and
2.
4 AUDIO OUTPUT CH-1/3 and CH-2/4
connectors (XLR 3-pin, male)
Output the audio signals of the channels selected with
the LINE OUT in the submenu. You can select two
combinations of output signals: channels 1 and 2, or
channels 3 and 4.
For more information about LINE OUT settings, see page 2-
21.
Note
The level can be adjusted from the control panel, but
mixed signals cannot be output.
5 MONITOR OUTPUT L/R connectors (XLR 3-
pin, male)
Output the audio signals of the channels selected with
the MONITOR L/R in the submenu. The level is
adjustable, and mixing is possible. Connect these
connectors when you want to output mixed signals.
For more information about MONITOR L/R settings, see
page
2-21.
You can also adjust the output level of the LEVEL knob with
the MONITOR in the submenu. For details, see page 2-21.
6 REF. VIDEO IN (reference video signal input)
connectors (BNC type) and 75 Ω termination switch
Input a video signal with color burst (VBS) or
monochrome video signal (VS) as reference video
signal. Set the 75 Ω termination switch to OFF when
the signal is bridged, and to ON when the signal is not
bridged.
7 VIDEO INPUT (analog composite video input)
connectors (BNC type) and 75 Ω termination switch
Input an analog composite video signal. Set the 75 Ω
termination switch to OFF when the signal is bridged,
and to ON when the signal is not bridged.
8 VIDEO OUTPUT (analog composite video
output) connectors (BNC type)
Output analog composite video signals. You can
superimpose timecode, menu settings, error messages,
or other information on the output of the 2(SUPER)
connector. (The superimposed information varies
depending on the setting of the SUPER in the
submenu.)
For more information about SUPER settings, see page 2-24.
For details about the superimposed information, see page 2-
9.
1-13
Chapter 1 Overview