Removing And Installing Coil And Ignition Lead - BMW R 1150 RT Repair Manual

Removing and installing coil
12 13
and ignition lead
•
Remove the seat.
•
Remove side panels (
a
e
Attention:
Fuel is flammable and a hazard to health. Observe all
applicable safety regulations.
•
Remove fuel tank ( 16.5).
a
•
Remove the ignition coil.
•
Disconnect plug.
•
Disconnect ignition lead.
•
Remove spark plug covers.
•
Pull off spark plug cap with special puller,
BMW No. 12 3 520.
•
Remove ignition leads.
•
Installation is the reverse of the removal proce-
dure.
•
Switch on the ignition.
•
Without starting the engine, fully open the throttle
once or twice so that the Motronic control unit
can register the throttle-valve positions.
12 3 520
46.8).
L
Note:
Disconnecting the battery deletes all entries (e.g.
faults, settings) stored in the Motronic control unit's
memory.
Loss of settings can temporarily impair the operat-
ing characteristics when the engine is restarted.
Checking ignition coil resist-
61 00 009
ance
•
Test with BMW MoDiTeC.
S120010
12.5