Konica Minolta Magicolor 3300 Service Manual page 59

Removal
1) Remove the CASSETTE of the TRAY 2 and 3. (RRP1.1)
2) Remove the COVER FRONT. (RRP1.1)
3) Remove the COVER R (PL14.2.3). (RRP1.2)
4) Remove the COVER L (PL14.2.1). (RRP1.3)
5) Remove the CHUTE ASSY TURN (PL14.3.7). (RRP1.4)
6) Remove the LINK ACTUATOR (PL14.4.6) spreading it from the convex portion at the connection to the
ACTUATOR NO PAPER (PL14.4.5) and pull out from the hole at the flap of FRAME TOP.
7) Remove the lower LINK ACTUATOR (PL14.4.6) spreading it from the projection at the connection to
the ACTUATOR NO PAPER (PL14.4.5).
8) Pull out the lower LINK ACTUATOR (PL14.4.6) from the hole at the flap of the OPTION FEEDER
frame.
Replacement
Replace the components in the reverse order of removal.
When replacing, position so that the wider portion is on the right side viewed from the
front. When replacing the LINK ACTUATOR (PL14.4.6), replace it after passing the tip
of the LINK ACTUATOR (PL14.4.6) into the hole on the OPTION FEEDER frame.
Chapter 3 Removal and Replacement Procedures
3-59