Konica Minolta Magicolor 3300 Service Manual page 55

Removal
1) Remove the CASSETTE of the TRAY 2 and 3. (RRP1.1)
2) Remove the COVER FRONT. (RRP1.1)
3) Remove the COVER R (PL14.2.3). (RRP1.2)
4) Remove the COVER L (PL14.2.1). (RRP1.3)
5) Remove the CHUTE ASSY TURN (PL14.3.7). (RRP1.4)
6) Remove the COVER CST SLIDE. (RRP1.20)
7) Remove the harness of HARNESS ASSY FDR2T (grey) (PL14.5.3). (RRP1.5)
8) Remove the harness of HARNESS ASSY FDR3T (blue) (PL14.5.4). (RRP1.6)
9) Remove the DRIVE ASSY OPF (PL14.5.5). (RRP1.7)
10) Remove the INDICATOR ASSY (PL14.5.9). (RRP1.8)
11) Remove the PWBA OPTFDR (PL14.5.1). (RRP1.10)
12) Remove 1 screw securing the BRACKET LOW PAPER to the OPTION FEEDER frame.
13) Remove the BRACKET LOW PAPER.
14) Remove 5 screws securing the GUIDE ASSY CASSETTE R (PL14.3.2) to the OPTION FEEDER
frame.
15) Release the claws (at 8 positions) securing the GUIDE ASSY CASSETTE R (PL14.3.2) to the OPTION
FEEDER frame.
16) Remove the LEVER LOW PAPER pulling out its tip out of the slit of the GUIDE ASSY CASSETTE R
(PL14.3.2).
17) Remove the GUIDE ASSY CASSETTE R (PL14.3.2) inclining it.
18) Repeat the steps 12 through 17 to remove the LOWER GUIDE ASSY CASSETTE R.
Replacement
Replace the components in the reverse order of removal.
When replacing the BRACKET LOW PAPER (upper and lower 2 PCS), align the screw
holes (at 2 positions) on both sides and nib (2 positions) of the OPTION FEEDER
frame, and align convex portion of the LEVER LOW PAPER to the hole to secure the
position.
Chapter 3 Removal and Replacement Procedures
3-55