Ir Mode; Irc-6 Operation - Chauvet Intimidator Wave 360 IRC User Manual

IR Mode

IRC-6 Operation

Page 30 of 34
IR mode allows the product to be controlled with an infrared remote controller. The
IRC-6 can remotely set the product to various modes; adjust the color, speed and
sensitivity; and set the strobe.
To set the product to IR mode, do the following:
1. Make sure the product is plugged into a power source and not connected to a DMX
cable.
2. Press <MODE/ESC>.
3. Use <UP> or <DOWN> to choose Run Mode.
4. Press <ENTER>.
5. Use <UP> or <DOWN> to choose IR.
6. Press <ENTER> and the IR indicator on the front of the Intimidator™ Wave 360 IRC
lights up.
Be sure the IRC-6 remote is pointing directly at the product and there is
nothing in between the remote and the product.
Some of the buttons on the remote work differently than what is indicated on
their labels. For example:
·
<A>, <UV>, and <W> control the Blackout function.
Please read the next section carefully.
The list below describes which features each button controls.
·
<BLACKOUT>, <A>, <UV>, and <W> - Turns LEDs on and off.
·
<AUTO> - Activates Auto mode. Use <0>–<9> and <+> and <-> to cycle through
Auto modes.
·
<SOUND> - Activates Sound mode.
·
<STROBE> - Activates the strobe. Use the <+> and <-> buttons to cycle through
strobe speeds.
·
<SPEED> - Adjusts the XY movement speed. Use the <+> and <-> buttons to cycle
through movement speeds.
·
<SENSITIVITY> - Adjusts sound sensitivity. Use the <+> and <-> buttons to cycle
through sound sensitivity levels.
·
<%> - Adjusts the total output of the LEDs. Use the <+> and <-> buttons to increase
or decrease the brightness of the LEDs.
·
<FADE> - Adjusts the speed and type of color fades. Press the button to switch
between fade and snap color changes. Use <+> and <-> to increase or decrease
the speed of the color changes.
·
<MANUAL> - Adjusts the white color in the LEDs. Use the <+> and <-> buttons to
increase or decrease the white color in the LEDs.
·
<R> - Adjusts the red color in the LEDs. Use the <+> and <-> buttons to increase or
decrease the red color in the LEDs.
·
<G> - Adjusts the green color in the LEDs. Use the <+> and <-> buttons to increase
or decrease the green color in the LEDs.
·
<B> - Adjusts the blue color in the LEDs. Use the <+> and <-> buttons to increase
or decrease the blue color in the LEDs.
·
<+> - Increases values for controls as described above.
·
<-> - Decreases values for controls as described above.
Intimidator™ Wave 360 IRC User Manual Rev. 1