D-Fi™ 2.4 Ghz (Ir/Standalone Mode Auto Sync) - Chauvet Freedom Par User Manual

D-Fi™ 2.4 Ghz
(IR/Standalone
Mode Auto Sync)
Freedom™ series User Manual (Rev. 6 ML)
The Freedom™ series can be configured to control two or more products with no
external controllers or with the IRC from CHAUVET ® (sold separately). To automatically
set up the D-Fi™ syncing function for IR/standalone functionality, do the following:
For the transmitting product:
1. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
2. Use <UP> or <DOWN> to select SYS.
3. Press <ENTER>.
4. Press <UP> or <DOWN> until S-tr appears on the display.
5. Press <ENTER>.
6. Press <UP> or <DOWN> until tA.s appears on the display.
7. Press <ENTER>.
8. The display should show t-AU.
For the receiving product(s):
1. Press <MODE> repeatedly until SYS, ACt, SLAv, or S-1r shows on the display.
2. Use <UP> or <DOWN> to select SLAv.
3. Press <ENTER>.
4. Press <UP> or <DOWN> until rA.S appears on the display.
5. Press <ENTER>.
6. The display should show r-AU.
Once the steps above are done, press and hold <AUTO> on just the transmitter and for
approximately 30 seconds. The display and signal LED will flash to indicate sync is
activated.
You can then back out to a more general menu level and configure the transmitting
product to operate it in Automatic Mode or with an IRC (sold separately).
To configure your product to work in Automatic Mode, refer to the
section of the Operation section of this manual.
To configure your product to work with the CHAUVET ® IRC, refer to the
Remote Control) section of the Operation section of this manual.
To add additional Freedom™ products, turn the synced ones off and repeat the above
steps with unsynced products. Once all products are synced, turn them all back on.
Auto scan syncing must be done within a distance of about 30 ft (10 m).
If you are experiencing antenna issues or need to improve signal quality, extend the
antenna outward away from the product and keep the line of sight between products
unobstructed.
Ensure that all linked products are configured to the same DMX personality (either
3-channel or 4-channel).
Automatic Mode
IRC (Infrared
Page 21 of 76