Table of Contents
Advertisement
Master Auto
Programs
4-Fixture Program
Master unit:
Slave unit:
Page 12 of 34
The Master Auto built-in programs control the actions of two or more Intimidator™ Wave
360 IRC units linked together by DMX data connection. A single Intimidator™ Wave 360
IRC (the master) controls the actions of another Intimidator™ Wave 360 IRC (the slave).
Configure the Master Auto programs in conjunction with the Slave modes as follows:
The Master Auto 4-Head program allows all 4 heads of four linked Intimidator™ Wave 360
IRC units to operate in unison. The master unit will be set to operate in the
M-4 program, while the slave unit will be set to operate in either Slave S-1, Slave S-2,
Slave S-3, or Slave S-4 mode.
Configure the units as indicated below.
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Mast Set.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to scroll to M-1, M-2, or M-4.
7.
Press <ENTER>.
8.
Use <UP> or <DOWN> to select M-4.
9.
Press <ENTER>.
1.
Press <MENU> .
2.
Use <UP> or <DOWN> to select Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Slave S-1, Slave S-2, Slave S-3, or Slave S-4.
5.
Press <ENTER>.
6.
Select Slave S-1 for 100% synchronized actions.
7.
Select Slave S-2, S-3 or S-4 for a delayed show with up to 4 fixtures, for up to 16
heads total, in the same direction but with a delay creating a wave effect.
8.
Press <ENTER>.
Intimidator™ Wave 360 IRC User Manual Rev. 1
Advertisement
Table of Contents
