Table of Contents
Advertisement
Configuration
(DMX)
Starting Address
DMX
Personalities
Intimidator™ Wave 360 IRC User Manual Rev. 1
Set the product in DMX mode to control with a DMX controller.
1.
Connect the product to a suitable power outlet.
2.
Connect a DMX cable from the DMX output of the DMX controller to the DMX input
on the product.
When selecting a starting DMX address, always consider the number of DMX channels
the selected DMX mode uses. If you choose a starting address that is too high, you could
restrict the access to some of the product's channels.
The Intimidator™ Wave 360 IRC uses up to 33 DMX channels in its 33-channel
personality, which defines the highest configurable address to 480.
If unfamiliar with DMX, download the DMX Primer from www.chauvetlighting.com.
To select the starting address, do the following:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select the Address.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to enter your starting address.
5.
Press <ENTER>.
The Intimidator™ Wave 360 IRC has two DMX personalities, a 33-channel personality
and a 17-channel personality.
To choose which DMX personality to use, follow the steps below:
1.
Press <MENU>.
2.
Use <UP> or <DOWN> to select Run Mode.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select DMX.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to select your DMX personality and press <ENTER>.
Page 11 of 34
Advertisement
Table of Contents
