Table of Contents
Advertisement
3. S
ETUP
AC Power
Fuse
Replacement
Power Linking
Power Linking
Diagram
Page 8 of 34
The Intimidator™ Wave 360 IRC has an auto-ranging power supply and it can work with
an input voltage range of 100–240 VAC, 50/60 Hz.
To determine the product's power requirements (circuit breaker, power outlet, and
wiring), use the current value listed on the label affixed to the product's back panel, or
refer to the product's specifications chart. The listed current rating indicates the
product's average current draw under normal conditions.
Always connect the product to a protected circuit (circuit breaker or fuse). Make
sure the product has an appropriate electrical ground to avoid the risk of
electrocution or fire.
Never connect the product to a rheostat (variable resistor) or dimmer circuit, even
if the rheostat or dimmer channel serves only as a 0 to 100% switch.
1.
Disconnect the product from power.
2.
Use a flat-head screwdriver to unscrew the fuse holder cap
from the housing.
3.
Remove the blown fuse.
4.
Replace with a fuse of the same type and rating.
5.
Screw the fuse holder cap back in place and reconnect
power.
Disconnect the product from power before replacing the fuse.
Always replace a blown fuse with another of the same type and rating.
The product provides power linking via the Edison/IEC outlet located in the front/back of
the unit.
You can power link up to 3 Intimidator™ Wave 360 IRC units on 120 VAC or up to
6 Intimidator™ Wave 360 IRC units on 230 VAC.
The power linking diagram shown above corresponds to the North American
version of the product ONLY! If using the product in other markets, you must
consult with the local Chauvet distributor as power linking connectors and
requirements may differ in your country or region.
st
1
Product
nd
2
Product
rd
3
Product
Additional Products
Intimidator™ Wave 360 IRC User Manual Rev. 1
Advertisement
Table of Contents
