Table of Contents
Advertisement
5. T
ECHNICAL
Product
Maintenance
Intimidator™ Wave 360 IRC User Manual Rev. 1
I
NFORMATION
Dust build-up reduces light output performance and can cause overheating. This can
lead to reduction of the light source's life and mechanical wear. To maintain optimum
performance and minimize wear, clean the product at least twice a month. However,
usage and environmental conditions contribute to increased cleaning frequency.
To clean the product, follow the instructions below:
1.
Unplug the product from power.
2.
Wait until the product is at room temperature.
3.
Use a vacuum (or dry compressed air) and a soft brush to remove dust collected
on the external surface/vents.
4.
Clean all external optics and glass/transparent surfaces with a mild soap solution,
ammonia-free glass cleaner, or isopropyl alcohol.
5.
Apply the solution directly to a soft, lint-free cotton cloth or a lens cleaning tissue.
6.
Softly wipe any dirt or grime to the outside edges of the external optics or
glass/transparent surface.
7.
Gently polish the external optics and glass/transparent surfaces until they are
free of haze and lint.
Always dry the external optics and glass/transparent surfaces carefully after
cleaning them.
Do not spin the cooling fans using compressed air because you could damage
them.
Page 31 of 34
Advertisement
Table of Contents
