Table of Contents
Advertisement
O
PERATION
Configuration (Standalone)
Use standalone configuration to operate the product without a DMX controller.
Static Mode
The Static mode allows for permanent dimmer and strobe presets without a DMX controller.
1.
Go to the Static main level.
2.
Select Dimmer or Strobe.
3.
Select the desired value (0–255).
Auto Programs
Auto programs allow for dynamic blinder effects without a DMX controller.
1.
Go to the Auto Show main level
2.
Select the desired auto program (Auto 1–3).
3.
Select the desired speed (1–100).
The auto programs cannot be edited.
Master/Slave
The Master/Slave mode allows a group of Ovation P-56UV products (the slaves) to simultaneously
duplicate the output of another Ovation P-56UV (the master) without a DMX controller.
To set each of the slaves:
1.
Go to the Master/Slave main level
2.
Select Slave.
To set the master:
1.
Go to the Master/Slave main level
2.
Select Master.
3.
Select a static setting.
•
The master is the one that runs a program.
•
Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master.
•
The master should be the first product in the daisy chain.
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1.
Go to the Dimmer Curve main level.
2.
Select the desired option (Linear, Square, Inverse Square, or S-Curve).
Dimmer Profiles
This setting determines how fast the output of the Ovation P-56UV changes when you modify the output value.
This setting provides four different options to simulate the dimming curve of an incandescent lighting product.
1.
Go to the Dimmer Mode main level.
2.
Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
Off: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3: The output follows the dimmer value based on the corresponding dimmer
curve, Dimmer 1 being the fastest.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the Ovation P-56UV.
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Ovation P-56UV User Manual Rev. 5
Page 11 of 16
Advertisement
Table of Contents
