Removing The Expansion Card Riser - Dell PowerEdge C4130 Owner's Manual

Table 5. Expansion card installation order
Card
priority
1 RAID H330 (low profile)
2 Mellanox dual port InfiniBand
adapter
3 Mellanox single port
InfiniBand adapter
3 10 Gb NICs (low profile)
4 10 Gb SFP+ NICs (low
profile)

Removing the expansion card riser

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1. Ensure that you read the
2. Follow the procedure listed in
3. Remove the PCIe shroud. See
4. If installed, disconnect the expansion card riser cables from the system board.
CAUTION: The expansion card riser cables must be removed before removing the expansion
card riser to prevent pin damage in the PCIe connectors on the system board.
Steps
Holding the touch points, lift the expansion card riser from the riser connector on the system board.
72
Card type Configuration A, B, C, and D
Slot priority
Safety instructions.
Before working inside your
Removing the PCIe
Max allowed
1 1
1, 2 2
1, 2 2
1, 2 2
1, 2 2
system.
shroud.
Configuration E
Slot priority Max
allowed
1 1
1 1
1 1
1 1
1 1