Back Panel Features And Indicators - Dell PowerEdge C4130 Owner's Manual

Back panel features and indicators

Figure 2. Back panel features and indicators—PowerEdge C4130
Item Indicator, button, or
connector
1 System identification
button
2 NMI button
3 iDRAC8 Enterprise port
4 Half-height PCIe
expansion card slot 1
5 Serial connector
Icon Description
The identification button on the front and back
panels can be used to locate a particular system
within a rack. When one of these buttons is
pressed, the corresponding system identification
button on the back flashes until one of the buttons
is pressed again.
Press the system identification button to turn the
system ID on or off.
If the system stops responding during POST, press
and hold the system ID button for more than five
seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup),
press and hold the button for more than 15
seconds.
Used to troubleshoot software and device driver
errors when running certain operating systems.
This button can be pressed using the end of a
paper clip.
Use this button only if directed to do so by
qualified support personnel or by the operating
system documentation.
Dedicated management port.
Allows you to connect half-height, half-length, low
profile PCI Express expansion cards.
Allows you to connect a serial device to the
system.
11