Removing A Heat Sink - Dell PowerEdge C4130 Owner's Manual

Removing a heat sink

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: Never remove the heat sink from a processor unless you intend to remove the
processor. The heat sink is necessary to maintain proper thermal conditions.
NOTE: To ensure proper system cooling, you must install a processor blank in any empty processor
socket.
1. Ensure that you read the
2. Keep the Phillips #2 screwdriver ready.
3. Follow the procedure listed in
4. Remove the cooling shroud. For more information, see
WARNING: The heat sink will be hot to touch for some time after the system has been powered
down. Allow the heat sink to cool before removing it.
Steps
1. Loosen one of the screws that secure the heat sink to the system board.
Wait 30 seconds for the heat sink to loosen from the processor.
2. Remove the screw diagonally opposite the screw you first removed.
3. Repeat the procedure for the remaining two screws.
60
Safety instructions.
Before working inside your system.
Removing the cooling shroud.