Table of Contents
Advertisement
Menu Item
Boot Sequence Retry
Hard-Disk Failover
Boot Option Settings
Network Settings screen
You can use the Network Settings screen to modify PXE device settings. Network Settings are only
available in UEFI boot mode. BIOS does not control network settings in the BIOS boot mode. For BIOS
boot mode, the network settings are handled by the network controllers option ROM.
To view the Network Settings click System Setup Main Menu → System BIOS → Network Settings.
Menu Item
PXE Device n (n = 1 to 4)
PXE Device n Settings (n = 1
to 4)
Integrated Devices screen
You can use the Integrated Devices screen to view and configure the settings of all integrated devices
including the video controller, integrated RAID controller, and the USB ports.
You can view the Integrated Devices screen by clicking System Setup Main Menu → System BIOS →
Integrated Devices.
The Integrated Devices screen details are explained below.
Menu Item
USB 3.0 Setting
User Accessible USB
Ports
Description
CAUTION: Switching the boot mode may prevent the system from
booting if the operating system is not installed in the same boot
mode.
NOTE: Setting this field to UEFI disables the BIOS Boot Settings
menu. Setting this field to BIOS disables the UEFI Boot Settings
menu.
If the operating system supports UEFI, you can set this option to UEFI.
Setting this field to BIOS allows compatibility with non-UEFI operating
systems. By default, the Boot Mode option is set to BIOS.
Enables or disables the Boot Sequence Retry feature. If this field is
enabled and the system fails to boot, the system reattempts the boot
sequence after 30 seconds. By default, the Boot Sequence Retry option
is set to Enabled.
Specifies which devices in the Hard-Disk Drive Sequence are attempted
in the boot sequence. When the option is Disabled, only the first hard
disk device in the list is attempted to boot. When set to Enabled, all hard
disk devices are attempted in order, as listed in the Hard-Disk Drive
Sequence. This option is not enabled for UEFI Boot Mode.
Configures the boot sequence and the boot devices.
Description
Enables or disables the device. When enabled, a UEFI boot option is
created for the device.
Allows you to control the configuration of the PXE device.
Description
Enables or disables the USB 3.0 support. Enable this option only if your
operating system supports USB 3.0. If you disable this option, devices operate
at USB 2.0 speed. USB 3.0 is disabled by default.
Enables or disables the USB ports. Selecting Only Back Ports On disables the
front USB ports, selecting All Ports Off disables all USB ports. The USB
keyboard and mouse operates during boot process in certain operating
27
Advertisement
Table of Contents
Troubleshooting
