Table of Contents
Advertisement
5.
Connect the power and signal cable(s) to the hard drive(s) in the hard drive cage.
Steps
1.
Lower the hard drive cage cover onto the hard drive cage.
2.
Slide the hard drive cage cover toward the back of the cage to engage it with the slots on the hard
drive cage.
3.
Use the screws to secure the hard drive cage cover to the hard drive cage.
Next steps
1.
Install the hard drive cage into the PSU 2 slot/2.5 inch hard drive slot on the chassis.
2.
Follow the procedure listed in
Removing 2.5 inch cabled hard drives from the hard drive cage
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only
perform troubleshooting and simple repairs as authorized in your product documentation, or as
directed by the online or telephone service and support team. Damage due to servicing that is
not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1.
Ensure that you read the
2.
Follow the procedure listed in
3.
Keep the Phillips #2 screwdriver ready.
4.
Remove the 2.5 inch hard drive cage. For more information, see
drive
cage.
5.
Remove the 2.5 inch hard drive cage cover. For more information, see
inch hard drive cage
About this task
CAUTION: To maintain proper system cooling, a minimum of two hard drives must be installed in
hard drive 0/E and 1/F slots.
Steps
1.
Remove the screws securing the hard drive to the hard drive cage.
2.
Remove hard drives 0/E and 1/F by performing the following steps:
a. Disconnect the signal/power cable from the hard drives.
b. Lift hard drive 0/E out of the hard drive cage.
c. Slide hard drive 1/F out of the hard drive cage.
86
After working inside your
Safety
instructions.
Before working inside your
cover.
system.
system.
Removing the optional 2.5 inch hard
Removing the optional 2.5
Advertisement
Table of Contents
Troubleshooting
