Assembling The Seal Ring Retainer; Assembling The Hydrostop Unit - KTM 350 EXC-F EU Repair Manual

6 FORK, TRIPLE CLAMP
6.13.9

Assembling the seal ring retainer

Info
The steps are identical for both fork legs.

6.13.10 Assembling the hydrostop unit

Info
The steps are identical for both fork legs.
–
Check the surface of the sliding bushings.
»
If the bronze-colored layer
rough:
–
Change the sliding bushings.
200665-10
–
Check the spring length.
Guideline
Spring length with preload spacer(s)
» If the measured value is larger than the specified value:
–
Reduce the thickness of the preload spacers.
» If the measured value is smaller than the specified value:
–
Increase the thickness of the preload spacers.
200666-10
–
Mount and grease seal ring
Lubricant (T158) (
–
Mount and grease O-ring
Lubricant (T158) (
–
Position pilot bushing support
201800-10
–
Mount and grease O-ring
Lubricant (T158) (
–
Mount washer
–
Mount shim stack
201783-10
–
Mount the new O-ring on hub
–
Mount the hub with washers
Info
It is possible that only one or no washer is present.
–
Mount and tighten adapter
Guideline
Hydrostop unit adapter
201784-10

under sliding layer
 .
p. 340)
 .
p. 340)
 .

.
p. 340)

.

with the smaller washers facing downward.

.

.

.

is visible or the surface is
472 mm (18.58 in)
M6x0.5 7 Nm (5.2 lbf ft)
43