12
FUEL TANK, SEAT, TRIM
Warning
Danger of poisoning Fuel is poisonous and a health hazard.
–
Fuel must not come into contact with the skin, eyes, or clothing. Do not breathe in the fuel vapors. If contact occurs with
the eyes, rinse with water immediately and contact a physician. Immediately clean contaminated areas on the skin with
soap and water. If fuel is swallowed, contact a physician immediately. Change clothing that is contaminated with fuel.
Main work
–
Check the throttle cable routing. (
–
Position the fuel tank and fit the two spoilers to the sides of the radiator bracket.
–
Make sure that no cables are trapped or damaged.
–
Mount the fuel tank breather.
–
Mount and tighten screw
Guideline
Remaining screws, chassis
M00182-11
(EXC‑F EU/AUS/BR, EXC-F SIX DAYS)
–
Position the collar bushings and horn, and mount and tighten screws
Guideline
Remaining screws, chassis
–
Connect the connector of the horn.
B01530-11
(EXC-F US, All XCF-W models)
–
Position the collar bushings and horn, and mount and tighten screws
Guideline
Remaining screws, chassis
–
Connect the connector of the horn.
M00181-11
(EXC‑F EU/AUS/BR, EXC-F SIX DAYS, XCF-W)
–
Plug in connector
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
–
B01533-10
Lubricate the O-ring and connect plug-in connection
(EXC-F US)
–
Plug in connector
–
Remove the wash cap set.
–
Thoroughly clean the plug-in connection of the fuel line using compressed air.
M00183-10
p. 55)
with the rubber bushing.
of the fuel pump.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the
fuel line clogs the injection valve.
Info
Route the cable and fuel line at a safe distance from the exhaust sys-
tem.
of the fuel pump.
Info
Under no circumstances should dirt enter into the fuel line. Dirt in the
fuel line clogs the injection valve.
M6
10 Nm (7.4 lbf ft)
M6
10 Nm
(7.4 lbf ft)
M6
10 Nm
(7.4 lbf ft)
of the fuel line.
91
.
.