Removing The Piston; Removing The Starter Drive - KTM 350 EXC-F EU Repair Manual

18 ENGINE

18.3.15 Removing the piston

18.3.16 Removing the starter drive

–
Push the cylinder upward.
Info
Only push the cylinder as far up as necessary to take the piston pin out.
–
Remove the piston pin retainer
–
Remove the piston pin.
–
Take off the cylinder and piston.
–
Push the piston upward out of the cylinder.
308599-10
Info
If no further work is to be performed on the cylinder and piston, the piston
can remain in the cylinder.
–
Take off cylinder base gasket
308600-10
–
Remove screw
308604-10
–
Insert special tool
Protection cover (75029090000) (
–
Attach special tool
turning in the screw.
Extractor (58012009000) (
Info
Ensure that the spring washers remain in place.
308605-10
–
Remove lock ring
–
Take off the starter idler gear with the washer.
308606-10

.
 .

.

in the crankshaft.
p. 346)

to the rotor. Hold the special tool and pull off the rotor by
p. 343)

.
146