Clutch; Checking/Correcting The Fluid Level Of The Hydraulic Clutch; Changing The Hydraulic Clutch Fluid - KTM 350 EXC-F EU Repair Manual

19

CLUTCH

19.1

Checking/correcting the fluid level of the hydraulic clutch

Info
The fluid level rises with increased wear of the clutch lining discs.
19.2

Changing the hydraulic clutch fluid

Warning
Environmental hazard Hazardous substances cause environmental damage.
–
Oil, grease, filters, fuel, cleaners, brake fluid, etc., should be disposed of as stipulated in applicable regulations.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
–
Check the fluid level.
Fluid level below container rim
» If the fluid level does not meet specifications:
–
Correct the fluid level of the hydraulic clutch.
M00208-10
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the screws.
Info
Clean up overflowed or spilt brake fluid immediately with water.
–
Move the clutch fluid reservoir mounted on the handlebar to a horizontal position.
–
Remove screws
–
Remove cover
M00208-10
(EXC‑F EU/AUS/BR, EXC-F SIX DAYS, XCF-W)
–
Fill bleeding syringe
Bleed syringe (50329050000) (
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove bleeder screw
syringe
L02463-10
(EXC-F US)
–
Fill bleeding syringe
Bleed syringe (50329050000) (
Brake fluid DOT 4 / DOT 5.1 (
–
On the clutch slave cylinder, remove bleeder screw
syringe
M00185-10

.
 
with membrane .

.
 
with membrane .

with the appropriate hydraulic fluid.
p. 338)
 .
 with the appropriate hydraulic fluid.
p. 338)

.
4 mm (0.16 in)
p. 338)
p. 343)

and mount bleeding
p. 343)

and mount bleeding
203