Installing The Water Pump Cover; Installing The Starter Drive - KTM 350 EXC-F EU Repair Manual

18 ENGINE

18.5.20 Installing the water pump cover

18.5.21 Installing the starter drive

–
Mount screws
Guideline
Screw, clutch cover
–
Tighten all screws in a crisscross pattern.
–
Mount the two-part water pump impeller
–
Mount and tighten nut
Guideline
Nut, water-pump wheel
308617-11
–
Mount the water pump cover with the seal ring.
Info
Ensure that the dowel pins are seated properly.
–
Mount screw
Guideline
Screw, water pump cover
–
Mount screws
308616-11
Guideline
Screw, water pump cover
–
Mount screw
Guideline
Screw, water pump cover
–
Tighten all screws in a crisscross pattern.
–
Grease the O-ring of the starter motor.
Long-life grease (
–
Position the starter motor.
–
Mount screws
Guideline
Screw, starter motor
308610-11
–
Put on gasket
308609-11

but do not tighten them yet.

.
M6

but do not tighten yet.

but do not tighten them yet.

with the washer but to not tighten yet.
p. 340)

but do not tighten yet.

.
M6x40 10 Nm (7.4 lbf ft)
 .
6 Nm Loctite
(4.4 lbf ft)
M6x25 10 Nm (7.4 lbf ft)
M6x40 10 Nm (7.4 lbf ft)
M6x25 10 Nm (7.4 lbf ft)
M6 10 Nm (7.4 lbf ft)
191
® 243™