Installing The Oil Screen; Installing The Spacer - KTM 350 EXC-F EU Repair Manual

18 ENGINE

18.5.36 Installing the oil screen

18.5.37 Installing the spacer

–
Oil the O-ring of the oil filter cover.
–
Mount oil filter cover
–
Mount and tighten screws
Guideline
Screw, oil filter cover
308572-11
–
Mount and tighten the oil drain plug
Guideline
Oil drain plug with magnet
308570-11
–
Push the oil screen with O-rings onto a pin wrench.
–
Push the pin wrench through the opening into the drill hole of the opposite engine
case wall and push the oil screen as far as possible into the engine case.
308571-10
–
Mount and tighten screw plug
Guideline
Screw plug, oil screen
308569-11
–
Grease the shaft seal ring before mounting.
Long-life grease (
–
Position the O-ring. Mount spacer
308568-10

.

.
M6

with the magnet and the new seal ring.
M12x1.5

with the O-ring.
M20x1.5
p. 340)
 with the bevel facing inward.
201
10 Nm (7.4 lbf ft)
20 Nm
(14.8 lbf ft)
15 Nm
(11.1 lbf ft)